It's as close as your local lumberyard or home improvement store. Luckily, traditional beadboard wainscoting is readily available and inexpensive. Sometimes the effect is achieved simply by separating sections of the wall with a chair rail molding and using a different paint color on the bottom section. Wainscotting is often made from wood beadboard painted white, but it can be made from many different materials, such as stained and finished hardwood paneling or a section of complementary wallpaper. Mod Podge Wall Treatment: an AT reader used tissue paper, mod-podge and cut out images to transform her bland work place bathroom walls into a textured wallscape with lots of personality. Affordable, non-permanent and available in a wide selection of styles, shapes and colours. It is also possible, though, to make very high wainscoting, a common treatment in dining rooms or dens. Blik wall decals: This is pretty much as simple as it comes. The top of the wainscot is often bounded by a chair rail molding. Traditionally, a wainscot rises to a level about one-third of the total height of the wall-about 32 inches on an 8-foot (96-inch) wall. Wainscotting is any wall covering that extends only part way up the wall. With a little creativity and a good design concept, you can cover walls with just about any material you can think of. So, for some of these coverings, consider installing them on a single accent wall rather than all four walls. But a word of advice: the more unusual and complex the wall covering, the more restraint you need when using them. Some are so highly textured and detailed that covering your entire house with them (or even an entire room) will produce visual overload. And that's a fine choice as well because wallpaper is a great way to introduce pattern and texture into wall surfaces.īut what if you're interested in wall covering ideas besides the obvious? Read further for some inventive ways to cover a wall. And if not paint, then wallpaper is the covering of choice in most other walls. And there's nothing wrong with that since you can't go wrong with a nice coat of good-quality interior paint. Most walls in the home get the usual covering treatment: interior paint in a flat, eggshell, or semi-gloss sheen. The Spruce Home Improvement Review Board.If you need to remove any residual dampness for the area, pop a Rubson Stop Humidity container in the space for a couple of days. Weather conditions need to be factored into the drying time, as high humidity levels will result in slower drying time. Note that drying and curing times must be adhered to for the product to provide maximum protection against damp. If you are using a water-based/acrylic paint you may apply the coatings directly onto the Dampseal. Repeat the process for the middle section and the top section with 24 hour intervals.Īfter 3 days of application of the first thinned coat to each section, apply the second coat to the entire section and allow 24 hours drying and curing time. Treat the lower section by applying a thinned coat of Plascon Dampseal (3 parts Dampseal to 1 part turpentine in volume) and allow it to dry and cure for 24 hours. Fill the holes with exterior Polycell Crack Filler (not interior crack filler) and proceed with the Plascon Dampseal application. Then place a fan close by if possible and allow this to run for a few hours. Ensure that the area also extends by 30cm to the left and right of the affected area.ĭrill 10mm diameter holes into the plaster using a masonry bit to allow moisture to escape. Is it a North-West facing wall (driving rain side)? Is there a garden with an irrigation system close or next to the wall? Is the water (if any) able to run-off easily and is the level of soil higher than the floor level of the kitchen? If the damp is occurring closer to the ceiling, then there are possible roof or parapet wall leaks.ĭivide the affected area into 3 horizontal sections with the top section extending at least 30cm above the affected area. If exterior, consider whether there are pipes running in or on the walls and whether there are taps and gullies. If it is interior, consider what room is on the other side, such as a bathroom. Take a close look at the area affected and inspect the surrounding walls and areas to determine where the damp in a wall is occurring, lower or middle wall, and whether the other side of the wall is interior or exterior. It is these salts, found in the cement plaster that when damp and trapped beneath the paint film can cause paint to discolour and peel. ![]() If the plaster is a dark grey colour, this indicates that the wall itself is excessively wet. It might be necessary to scrape off some of the existing paint down to the plaster.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |